SGMGH-06A2D2E | Yaskawa Motor for high precision machine tool SGMGH-06A2D2E

Servo driver SGD7S.
Maximum applicable motor capacity: 0.05kW.
Voltage: single phase \/ three phase AC200V.
Interface: MECHATROLINK-II communication command type.
Design sequence: A.
Hardware purchase pieces: no purchase pieces.
Select servo.
Since the Yaskawa since the beginning of 1992 sales of sigma series, has always attached great importance to technical exchanges and customer,
In order to solve the new problem of customer machinery, and repeatedly to carry out technical innovation Yaskawa SGMGH-06A2D2E SGMGH-06A2D2E
High speed, high accuracy, the use of convenience in recent years has been the requirement of customers,
But the degree of its requirement is continuously deepening.
2014, the servo drive upgrade to have 7 major advantages",
Provide solutions for customers unique yaskawa Yaskawa SGMGH-06A2D2E.
With its excellent performance, convenient operation, long life cycle, etc.,
In all these areas will have great potential, provides solutions to the shocking. "Choose servo, choose"
Large capacity SGMVV type servo motor.
Rated output: 37KW.
Voltage: three phase AC400V.
Serial encoder: 20 bit absolute value type.
Rated speed: 800r/min Yaskawa SGMGH-06A2D2E.
The main mechanical structure: support mounting type, straight shaft (no keyway and screw).
Optional parts: with hold brake (DC24V).
The use of small, low inertia servo motor, also can give full play to the strength of the mechanical properties.
The new model SGMVV with a rated output of 22~55KW, the amount of passenger speed 800r/min and 1500r/min products.
After the motor is installed, the phase is started to run immediately.
Even if the servo is not adjusted, as long as the moment of inertia is within the allowable range,
Even if the load changes, it can be driven stably, and the vibration will not happen.








Servo motor SGMGH type.
Rated speed: 1500r\/min.
Power: 5.5kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit relative value.
Design sequence: high precision machine tool.
Shaft end: taper 1\/10, with parallel key.
Optional parts: no brake oil seal.
High speed feed series: high speed running when no load.
Complete separation of the main circuit and the control circuit,
Alarm can only turn off the main circuit power supply, easy to maintain SGMGH-06A2D2E.
Parameter setting device.
The parameters can be directly entered by the servo drive body.
Saving wiring.
Using a serial encoder, encoder wiring number tthan the original product reduced by 1\/2 SGMGH-06A2D2E.
Multi in one control: the use of the parameters of the switch can not use the torque, position, speed control